B1b Bomber Twin 50mm | Kyle's Designs RC

Model Images

This menacing beautiful piece of machinery looks insane in the air. I wanted to design a version of the B1b that would be easy to build and light weight enough to hand launch. I did just that. This model can easily be hand launched by an experienced EDF pilot. If you have an airstrip field you can easily add some fixed gear on this with all the flat surface on the bottom of the fuselage. Once in the air this bird flies like a beginner jet. I know many will expect a swing wing design but it would be too heavy as a 3d printed platform. I Picked the Mid sweep wing position that would be the most well rounded for all RC flying conditions. Low speed and high speed. There are so many 3d printable designs for sale these days. Please make sure every designer posts uncut UNEDITED full flights of every plane. You want to see how the plane hand launches and lands. Maiden Flights https://youtu.be/cW1I1JtoIIs Final Check Flights https://youtu.be/FOVleoW_CBg Parts needed: twin 50mm EDF's I use the Xfly Galaxy https://a.co/d/ay19Ynq Twin 40mm ESC's (any) https://a.co/d/8pIPm1d ESC wire extensions (2X) https://a.co/d/1gbmFNo 2x 8mm OD carbon tubes 14" each. Four 4.3g servos https://a.co/d/a2gmqHZ xt60 y adapter for your dual ESC's 1.2mm pushrod with z bends velcro for the electronics and battery in the cockpit I recommend flying your first flight with a 1500 4s lipo. It will be short 2-2.5min to trim and get the maiden done. Then you can run the 2200 4s.