Buy today at: https://cults3d.com/en/3d-model/gadget/darkstar-twin-40
This is the only Darkstar available that can easily be hand launched and easily flown fast or slow in a park. This gorgeous (probably one of the coolest looking) jet has lots of scale details and panel lines thanks to the detail work from Thomas Heuer! When you fly this thing you wont believe you're flying a scale Darkstar from the movie Maverick! This is easily an intermediate EDF jet.
Flight videos!! (never buy a 3d printed plane without multiple uncut videos of it flying, hand launching and landing)
https://youtu.be/v3lo_oHYHR4?si=36WTm5ZVJytFHuzY
ONLY 650 + - Grams flying weight!
34" x 19"
Parts needed to complete:
Fans (2x) https://a.co/d/gQCJzqY
Servos 3x) https://a.co/d/7b96cUG
ESC (2x) https://a.co/d/99Spw37
1300-1500 4s https://a.co/d/2hbTh2k
y splitter for receiver https://a.co/d/2BvmSld
Y splitter battery https://a.co/d/24vTr8i
2x 10mm magnets
1.2 mm pushrod
velcro
3D printing settings
like all my designs def use active foaming LW PLA!
1 wall
2top and 2bottom layers
3% gyroid works well for all parts. you can use 2% gyroid for the last two rear fuselage sections, vertical tails and EDF covers to decrease the tail weight and make the balance easier.