Buy today at: https://cults3d.com/en/3d-model/gadget/draken-50mm-edf-jet
NOTE~! dont print Fuse 5 in the zip folder. Print the new fixed version "draken fuse 5 fixed. The original was corrupted.
I'm not going to bore you wonderful descriptions of how well this Draken actually flies. I'm going to ask you to watch this video. Draken Available!
https://youtu.be/BWsB6YdmzQk If you want an easy to print, easy to build (1 hour), easy to HAND LAUNCH, easy to land Draken.... here you go!
This Draken is only 650g all up flying weight. It WILL 100% cobra and flat spin. All while being easy to fly. I cant say enough about this model.
Parts Needed:
Any 50mm fan. Powerfun or Xfly.
40 amp ESC
2x 9g Servos with 10" extensions
1.2mm push rod
velcro
10mm magents for canopy
CA glue to assemble
Hot glue for the EDF and servos
3D printing settings
Dial your particular printer in for active foaming LW pla
1 wall
2 top 2 bottom
3% grid for Fuselage 1-5, canopy and edf cover
4% gyroid for Fuselage 6-8
3% Gyroid for wings, elevons and tail