Buy it now at: https://cults3d.com/en/3d-model/gadget/eurofighter-twin-40mm-edf
I'm really loving these xfly twin 40 platforms. they allow for a scale fuselage and deliver a good 1000g of thrust! This Eurofighter takes great advantage of these twin little motors. The Jet flies very floaty. Hand launches and lands super easily. The build goes together quickly.
Specs:
865g all up weight
1000g thrust
35" long
25.5" wide
The Eurofighter has four control surfaces. It utilizes my special full flying canards. You simply hot glue the servos into the slots and CA glue the full flying canards into the symmetrical servo head
Parts needed
2x Xfly 40mm EDF's https://a.co/d/hZRbLI4
4x 9g servos https://a.co/d/bjajoNS
2x 20amp ESC's https://a.co/d/gmdwi0D
2x ESC motor wire extensions https://a.co/d/c1TXLK6
CA glue
velcro
2 magnets, i buy the assortments.
Flight video https://youtu.be/gJ9bl3cFmjE?si=eYC7xi8u1NyvaOWe
3D printing settings
Active foaming LW pla highly recommended. youll need to dial your printer in for LW pla.
1 wall
2 top and 2 bottom layers
3% Grid infill is all great all around or use gyroid infill