Buy today at: https://cults3d.com/en/3d-model/gadget/fa-xx-50mm-rc-dominance-fighter
Title Says it all guys. I've pulled out all the tricks here for this one. This must be considered one of the best all around because its so easy to launch, fly and land!
It builds off the success of the Mini Delta Fighter. Probably one of everyone's favorite designs, but better. This fighter is what I imagine the new FA\XX carrier jet / drone will be.
It prints easy, it builds in 1 hour, it uses a single 50mm fan, it will fly on a 1300-2200 + lipo.
Also as a bonus! you can scale this up to any size you feel like. 64,70,80 or even 90mm. It will take off from grass on anything 64 or up :-)
Parts needed
50mm Xfly https://a.co/d/bgef8we
any 40 amp ESC
2x 9g servos https://a.co/d/hIfRclu
velcro
4x 10mm magnets
Maidnen flight https://youtu.be/D5FFGOjf_4A?si=3HHPSBn9nxip7m7S
Thomas’s flights! https://youtu.be/wlN-79dU1Xo?si=TAfwk1VVxNlTdO3h
3D printing settings
Highly recommend using active foaming LW PLA!
1 wall!
2 top and 2 bottom
I like 3% grid or 3% gyroid if you want more strength. Usually 3% grid for fuselage parts and 3% gyroid for wings and elevons