Buy today at: https://cults3d.com/en/3d-model/gadget/mig-29-twin-40mm-edf-jet
This is an iconic design. the Mig 29 always lends itself to mazing RC performance. It feels somewhere between my F18 and F15 (not surprisingly). The print and assembly is VERY easy and stress free. It has a great balance of performance to comfort when flying. The direct drive linkage less tails are amazing. They allow you to use lots of control throw without jerkyness and numbness. It also performs the best most graceful scale style flat spins of all the twin 40's. ONLY WEIGHS 640 ready to fly.
Parts:
Xfly Twin 40mm edfs
20 amp ESC's 2x https://a.co/d/a1eczlv
y adaptor for the dual ESC's https://a.co/d/5N3F35s
1300 4s lipo recommended for best performance and weight distribution.
2 9g servos https://a.co/d/7Bih3OT
Medium or thick CA glue to assemble
hot glue for the EDF's and servos
velcro for the battery
2x 8-10mm magnets
Builds in about 1.5 hours no other special stuff
Flight video
https://youtu.be/TInqjroHzr8?si=OBCS8AdGfnUmsBWm
3D printing settings
like all my designs. I only use active foaming LW PLA like 3d lab print.
1 wall!
2 top and 2 bottom layers
3% grid infill for all fuselage
3% gyroid for wings and tailerons