Buy today at: https://cults3d.com/en/3d-model/gadget/saab-jas-39-gripen-64mm-edf-jet
This Gripen flies like you mated my F16 with my Mirage 2000. it rolls like a drill bit and will cobra! flies very stable. My wing design makes my jets fly like they have a gyro inside. this will not wing tip stall. it will gently drop the nose. hand launches super easy. Very easy to print and build.
https://youtu.be/E__ZKzMcAyM?si=gubb960S6NkB2uVY
All my builds simply CA glue together. No instruction manual required. Just print the parts, glue the parts together and run the servo wires down the tubes. Please join my Facebook Group to get more info on building if you need help.
Parts:
-64mm EDF without a lip prefered. You can absolutley use a lip but you may need to dig away at the hatch
- two MG 9G servos
-1.2mm push rod
-assortment of 5-15mm magnets. I used 10mm on this one
-1500-2200 4s lipo
CG is balanced on the bumps under the wing. This will give you a slightly nose heavy CG for the first flight. Id recommend having a tiny 1mm elevator up trim on the first flight.
https://www.facebook.com/share/MQvh5g6mbCpXGjuX/?mibextid=K35XfP
3D printing settings
LW PLA recommended
1 wall
1 top layer
1 bottom layer
2.5% grid infill on everything other than the elevons
3.5% grid infill on elevons