Buy now at: https://cults3d.com/en/3d-model/gadget/stryker-twin-40mm-fpv-platform
This was a blast to design, print, build and FLY FPV! The airframe lends it self to FPV due to the light wing loading and ample space for FPV parts and easy access to the battery bay. It flies very stable like a traditional delta wing and is very easy to build
I've done a video on how to heat form the clear dome for the nose of the Stryker
Parts Needed
xfly twin 40 mm EDF's https://a.co/d/fHQcEXp
2x 9g servos https://a.co/d/0T9JBlV
2x 20 amp esc https://a.co/d/fHQcEXp
y adaptor https://a.co/d/dsre1DD
y adaptor for esc wire https://a.co/d/1yLjp5n
any 13-1500 4s lipo
6x 10mm magnets
velcro
FPV parts I used were DJI 03 air and the V2 goggles. youre welcome to use anything you have available.
FPV Flights
https://www.youtube.com/watch?v=ataRkFwSbA4
Maiden flights
https://youtu.be/6F0pLAliacE?si=D6OBuINav1t4J3ac
How to form the clear dome
https://youtu.be/3Lt_x55g6R8?si=DxZtpnJz_JxFylG4
3D printing settings
You must dial your printer in for active foaming LW pla. Pre foamed PLA is 30% heavier and doesnt provide a good result
1 wall
2 top and 2 bottom layers
3% grid for everything BUT....
Fuse 1 should be printed in regular PLA : 1 wall, 2 top and 2 bottom 2% grid infill
Elevons should be LW PLA but 5% grid or gyroid with 2 walls