I was genuinely surprised at how well this flew on its maiden flight. It was literally perfect. The only thing i had to adjust was the roll rate. This jet prints extremely easy and can be built in 1 hour!!
plane is 22.0" (559mm) long and 20.0" (508mm) wide. You can print this on a 220/220/220 build plate
parts used
Power fun 50mm 4s
1300-1500 4s recommended. 2200 4s can work fine just a little heavier
velcro
assorted magnets
2x 9G MG servos
****The jet will fly great but it may nose down on hand launch. You should install the file called “ thrust line exhaust tube” if you’re not a good thrower. The thrust tube has a small “v” that lines up with the vertical tail
I recommend setting the control horns on the middle setting. I used 100% rates and travel on elevator. I highly recommend 40-50% rate on roll and 10-20% expo on roll . THis will drillbit roll!
Flight Video This Cartoon Mirage flew awesome!!
https://youtu.be/cDakXK_0EYw
Aircraft Specifications
- EDF: single 50mm
- Skill Level: Beginner