Buy now at: https://cults3d.com/en/3d-model/gadget/f117-stealth-fighter-twin-40mm
This design is super special. Its only 700g all up flying weight with a 2400 4s. It makes 1000g of thrust! it underhand launches, I repeat! it UNDER HAND launches easily. NO need for a complicated bungee launch, catapult or landing gear, no dolly launches. no need for a friend to throw. On top of all this, it lands like a soft comfy pillow.
the plane builds super easy. and prints easy. I built the plane in 1 hour.
250/250/250 build plate recommended. you can absolutely print this on a smaller printer. My designs can be sliced in any orientation and printed in halves or quarters and you just glue them back together.
parts needed
twin 40mm Xfly EDF's https://a.co/d/0fRbmEVM
twin 20 amp ESCs https://a.co/d/0cb0AY69
2x 9g servos https://a.co/d/03nMUXRn
3 10mm magnets
velcro
hot glue
CA glue
Maiden Flight https://youtu.be/oDsDL7Y-j1s?si=TpLqJy_1AYbmLWOo
Assembly Videos https://youtu.be/2QS8bE-hRQs?si=TLWxGq3hGb0NzQNI
More flights https://youtu.be/wVJ-GjJoaac?si=KRTaNVFO08Fwcote
3D printing settings
like all my designs
1 wall!
2 top and 2 bottom layers
IMPORTAINT!!!
fuselage can be printed in 2% gyroid infill
wing parts and elevons plus vertical tails must be 4% gyroid. this is for correct strength