Buy today at: https://cults3d.com/en/3d-model/gadget/shmiggen-50mm-and-64mm-edf-jets-cartoon-viggen
well... this ones special. Super special. It flies amazing as you can see from my videos. I'm offering this jet as a double pack. 50mm and 64mm. I would challenge any 3d printed jet designer to compete against this little fatty.
Pros:
1. looks funny and cute
2. flies unbelievably slow (cartoon planes never do)
3. tons of control, you can perform almost every stunt
4.lands light
5. easy to hand launch! one of the easier ones.
6. prints super easy. Just dial in your printer and print, then glue the parts togther
7. easy to build. I build mine in less than 1 hour
8. its FAST
9. Its the coolest plane at any field lol
10: DURABLE! I crashed my 50mm 4 times and it has very little to no damage.
11. fit and finish is pretty darn good.
Cons:
I designed the jet to sit in a squat high alpha when balanced on the CG nubs. dont worry this is totally normal :-)
The 50mm was designed to work with the QX/powerfun/xfly. They all fit different. just use some hot glue to hold it in place. The 64 was designed around the freewing 64mm 6s. Doesnt mean you cant run a smaller xfly or qx 64. fitment might be a little big. I always recommend priting only the EDF holding section and verify fitment before printing the whole plane. you can scale the whole thing 1% smaller if the fan is loose.
Parts:
Any 64mm or 50 for the respective jet
canopy magnets
velcro for the battery
hot glue for the edf
CA glue for the whole plane
any size battery you choose for the 64. between 1500-2600
50mm really likes the 1300-1500. Ive flown the 2200 4s with the 50mm but it just lands a little heavier.
Flight videos of the 50mm https://youtu.be/mulNFeFda4E
Flight videos of the 64mm https://youtu.be/jOQvgNkh104?si=M4ckYfzxj3qRpVPd
3D printing settings
just like all my jets
3% infill (grid or gyroid)
1 wall, 2 top 2 bottom
LW active foaming PLA