Buy today at: https://cults3d.com/en/3d-model/gadget/cartoon-mirage-2000-50mm-edf
I was genuinely surprised at how well this flew on its maiden flight. It was literally perfect. The only thing i had to adjust was the roll rate. This jet prints extremely easy and can be built in 1 hour!!
plane is 22" long and 20" wide. You can print this on a 220/220/220 build plate
parts used
Power fun 50mm 4s
1300-1500 4s recommended. 2200 4s can work fine just a little heavier
velcro
assorted magnets
2x 9G MG servos
****The jet will fly great but it may nose down on hand launch. You should install the file called “ thrust line exhaust tube” if you’re not a good thrower. The thrust tube has a small “v” that lines up with the vertical tail
I recommend setting the control horns on the middle setting. I used 100% rates and travel on elevator. I highly recommend 40-50% rate on roll and 10-20% expo on roll . THis will drillbit roll!
Flight Video This Cartoon Mirage flew awesome!!
https://youtu.be/cDakXK_0EYw
3D printing settings
like all my jets
1 wall, 1-2 top and bottom and 3% infill. 4% is slightly stronger
LW active foaming pla recommended.