Buy today at: https://cults3d.com/en/3d-model/gadget/mini-delta-fighter-50mm
This little guy is NUTS! 50mm power fun on 3s and this thing rocks! it flies slow and fast. You wont believe how fast this is on 3s. And you wont believe how crazy soft this thing lands. The whole just prints in 2 build plates on a 250/250/250 printer and only weights 530 grams.
super compact
24" long
21" wide
530g flying weight
Powerfun 50mm
https://amzn.to/4c6kAbq
40am esc
2200 3s
2 9g servos
velcro
2 magnets
Pre flight setup!
Balance the jet on the printed in CG nubs under the wings. I would run the aileron (roll) axis around 40% travel and run maybe 80% travel on the elevator. I don’t like expo but 10-20% on roll is good. Throw it by holding underneath the rear and index finger around the back of the jet. You’ll feel the exhaust on your finger. Landing is a breeze. Bring it in slow and flare right before you touch and it will plop down super light.
Flight video will be here
https://youtu.be/D7mn57xy5qk?si=gHMaffi332_wPZ8-
build video will be here
3D printing settings
LW pla or regular pla should be fine
1 wall
1-2 top layers
1-2 bottom layers
3% grid infill