Buy now at: https://cults3d.com/en/3d-model/gadget/avro-arrow-cf-105-50mm
This design was fun from the beginning to the end. This was by far one of the most requested airplanes that people wanted me to come out with. The plane flies very smooth. It’s easy to build and it’s easy to print. In general, the airplane is slightly larger than my other 50 mm. It has good stable flight characteristics. It has very light wing loading and will land very softly.
Flight video https://youtu.be/aSs2Oh-9FWM?si=zKze3jhbnTU5tZW3
Parts needed:
Xfly 50mm EDF 4s
Any 40 amp esc
3.5mm esc extensions https://amzn.to/43r5Hyf
Two 9g servos
1.2mm push rods with zbends
Velcro for securing the battery
Hot glue for the Edf and servos
Ca glue to assemble
3D printing settings
Always dial your specific printer and slicer to print active foaming lightweight PLA
Once you have done this
1 wall
2 top and bottom
3% grid or gyroid
4% for elevons
Print the canopy latch in regular PLA full strength