Buy today at: https://cults3d.com/en/3d-model/gadget/j10-64mm-edf-jet
I’ve always been fascinated with the J10. Ever since I saw the RC turbine Carf j10s with vectored thrust I was amazed and wanted a park flier sized version. I have owned a few foam versions, but they never flew quite right this 64MMJ 10 flies incredibly it has very large control surfaces so it’s the most maneuverable jet I’ve made so far you will need to lower the rates and use exponential. I have gone through three revisions, I have also tried two power units a normal 4S 64 mm version and a high-powered 6S 64 MM version both fly great. I have included two EDF covers to help fit your fan unit. The sky is the limit with this j10. you can make it a docile flyer or a wild, wild aerobic animal. This J10 intake and exhaust has been optimized for maximum thrust.
Flight videos:
https://youtu.be/mXde0V7ojzw?si=OAriz-UZgmnb8zMQ
Customers build https://youtu.be/OBhuf1YdUw4?si=hZFcvn3ckxKpzQpd
Parts
Any 64mm you choose. 4-6s
Two quality mg 9g servos
Velcro
Assortment of magnets
CA glue
Hot glue for the EDF and EDF cover
Build:
Simply CA, glue everything together starting at the rear. Install the EDF and run extensions down the upper chamber before you glue the EDF section to the subsequent you have this done you can glue everything else together servo wires will need a 6 inch extension servo wires will feed Through the upper chamber you just need to be patient and keep trying to feed it through.
3D printing settings
LW PLA active foaming
1 top layer
1 bottom layer
1 wall
3% infill (grid or gyroid)