Shmiggen 50mm and 64mm EDF jets (Cartoon Viggen)

well... this ones special. Super special. It flies amazing as you can see from my videos. I'm offering this jet as a double pack. 50mm and 64mm. I would challenge any 3d printed jet designer to compete against this little fatty. Pros: 1. looks funny and cute 2. flies unbelievably slow (cartoon planes never do) 3. tons of control, you can perform almost every stunt 4.lands light 5. easy to hand launch! one of the easier ones. 6. prints super easy. Just dial in your printer and print, then glue the parts togther 7. easy to build. I build mine in less than 1 hour 8. its FAST 9. Its the coolest plane at any field lol 10: DURABLE! I crashed my 50mm 4 times and it has very little to no damage. 11. fit and finish is pretty darn good. Cons: I designed the jet to sit in a squat high alpha when balanced on the CG nubs. dont worry this is totally normal :-) The 50mm was designed to work with the QX/powerfun/xfly. They all fit different. just use some hot glue to hold it in place. The 64 was designed around the freewing 64mm 6s. Doesnt mean you cant run a smaller xfly or qx 64. fitment might be a little big. I always recommend priting only the EDF holding section and verify fitment before printing the whole plane. you can scale the whole thing 1% smaller if the fan is loose. Parts: Any 64mm or 50 for the respective jet canopy magnets velcro for the battery hot glue for the edf CA glue for the whole plane

Aircraft Specifications

• EDF: single 64mm
• Skill Level: Beginner