Guys!!! F-35C, the carrier variant that has larger wings, more lift and easier to fly all around. easy print and easy build. only two servos! I had such a great experience with my direct taileron mounting system on my f16 I couldnt wait to do the same with the F35! this is an all around great jet.

This design is super special. Its only 700g all up flying weight with a 2400 4s. It makes 1000g of thrust! it underhand launches, I repeat! it UNDER HAND launches easily. NO need for a complicated bungee launch, catapult or landing gear, no dolly launches. no need for a friend to throw. On top of all this, it lands like a soft comfy pillow. the plane builds super easy. and prints easy.

6.30.24 update! One of my great and talented customers / test pilots Thomas Heuer loved the Dagger 1 so much he developed a thrust vector system that uses the same two servos for the elevons and nothing else! just print the parts and assemble it. It doesnt need to be put on a switch either! This was a custom design I actually dreamed about one night. I combined an F22 with an SU-47.

Latest F16 is the Gen 2. I have learned alot in the past 8 months and it all shows on the latest Gen 2 Viper. You will learn a few things with this new iteration. You DONT need a wing spar and you can fly a jet like this with 2 servos and NO control linkages or push rods. This viper uses the symmetrical servo head glued into a slot in the Taileron.

Ok guys, the long awaited F16/XL will not disappoint. Its super easy to print, build and fly. It could be one of the best flying airframes i've ever flown. Please watch my flight video below to see how well this actually flies. It flies slow and fast. the envelope is giant!

The F7U Cutlass was a carrier based US navy jet. It may not have been the greatest US carrier fighter but it sure flies great as an RC jet! super docile and super predictable. Just like all my planes it prints easy, builds easy and flies amazing. This and the F4D Skyray can be considered trainer jets 100%. if you're looking for an easy to fly and throw edf this is it.

NASA designed the X-36 to be a tailless fighter agility research vehicle. I always loved how it looked and wanted the challenge to make it fly. The vertical tail version flies very well! super agile and has very light wing loading. The build is very easy. It hand launches very easily and flies with a very unique character. I would say this plane is an intermediate and above.

You'd be hard pressed to find another edf Jet easier to fly, foam (purchased) or 3d printed. This is 100% the easiest EDF jet to fly I've flow or seen fly on youtube. It prints fantastic and it assembles easily. This Skyray hand launches super easy and will fly at 1/2 throttle and land like butter.

This is by far my best design to date. The fit and finish. The lines and the packaging. The YF-23 has been one of those models that is extremely difficult to not only design but fly and fly well. When I fly a design for the first time (maiden) and it flies like this did... its a winner. IMO there have been ONLY 2 RC YF23's that flew well. the banana hobby version from 8 years ago and mine.

I was genuinely surprised at how well this flew on its maiden flight. It was literally perfect. The only thing i had to adjust was the roll rate. This jet prints extremely easy and can be built in 1 hour!! plane is 22" long and 20" wide. You can print this on a 220/220/220 build plate parts used Power fun 50mm 4s 1300-1500 4s recommended.